Logo

C1914 Engine Code Repair

Meaning of C1914 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C1914 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C1914 code is occuring now you should check C1914 repair processes.
Now don't ask yourself; What should you do with C1914 code ?
The solution is here :

C1914 Possible Solution:

C1914 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

C1914 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

1
Fuel And Air Metering

9
Engine Oil Temperature Sensor Malfunction

1
Cold Start Injector 1 Malfunction

4
Exhaust Gas Recirculation Sensor B Circuit High

Regarding the C1914 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C1914 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1914 engine trouble code is about Exhaust Gas Recirculation Sensor B Circuit High.

Main reason For C1914 Code

The reason of C1914 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

C1914 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.